ComAp Smart Home - Product Information; System Compatibility; Package Contents

6 7
19.5
If there is a disconnection problem, bring the thermostat within 10 cm of the
heating module and then restart the thermostat.
In the event of communication problems:
• Disconnect the gateway from the modem and reconnect it; the two gateway LEDs
must be permanently lit.
• Remove the heating module from the holder and put it back; the right and le
LEDs must be lit.
If the thermostat is no longer paired with the heating module, contact Customer
Service.
1
2
3
ERROR CODES
19.5
1
Problem with pairing
2
Communication problem
3
Disconnection
STARTING UP
Welcome
Heating
command
Stop
command
Room
temperature
Setpoint
temperature
Heating o
Heating in
progress
LED display
Heat indicator
Activation zone
Arrows
OPERATION BUTTONS
19.5
You can activate the product
by tapping the activation area
The setpoint temperature
can be set using the
arrows
DURING INSTALLATION
Updating, please be patient.
Pairing with the module
Restart
THERMOSTAT