Attaching the Canopy
Attaching the Canopy
1.
Confirm
the canopy is facing in the proper direction.
2. Fully insert the canopy holder (male) into the canopy hold-
er
(female) until a click is heard.
4.
Fasten the canopy velcro together around the handle (2 places).
Removing the Canopy
Pull the velcro apart, squeeze the bottom of the canopy holders
(male) and pull the canopy up from above the canopy holder
(female). This must be done on both sides of the canopy.
CAUTION
Failure to fully secure the canopy holders can cause
the holders to bend. When storing the stroller by
laying it down, be sure the canopy is off the ground
to prevent it from bending.
1. Stand behind the stroller.
2.
Locate the small open-
ing on each rear wheel
assembly.
3.
Locate the small chrome pin on each rear
stroller leg.
Attaching the Rear Wheels
5. Insert the leg into the wheel assembly
until the small chrome pin locks into
the opening.
- 4 -
WARNING
Weight in cup holder must not
exceed 1 lb.
4. Align the small opening on the wheel
assembly with the chrome pin on the
stroller leg.
3. Unfold the canopy by pressing Canopy Levers down and pulling
canopy to the most open position.
1.
With guardrail removed, attach cup holder
over guardrail post.
2.
Reattach guardrail to secure cup holder.
Using the Cup Holder
To Next Page
Loading...
