The list of WAN connection name that has been created.
If you want to create a new WAN connection, please select
“Create WAN Connection” and input other Parameter at the same
time and then click “Create” button. If you want to edit WAN
connection, please select the wan connect name you want to edit
and change some Parameter and then click “Modify” button. If
you want to delete one connection, please select the wan
connection you want to delete and then click “Delete” button.
Name of new connection that you want to create.
Bridge/Route. The device works on route mode with this WAN
connection.
Checked indicates NAT function is enabled. Unchecked indicates
NAT function is disabled.
Checked indicates the packets are transmitted by the PON port
take VLAN tag. Unchecked indicates the packets are transmitted
by the PON port don’t take VLAN tag.
Input the VLAN ID you want to set. Range is 0~4094. Input 0
means don’t use any VLAN.
Select VLAN priority you want to set. Range is 0~7.
Max transfer unit. Default Value (in Byte):
1500(static/DHCP) or 1492(PPPoE).
Method of WAN connection Obtains IP address. If link type is
PPP, PPP TransType will be PPPOE; if link type is IP, IP Type
will be static or DHCP.
Service mode indicates what the wan connection is used for.
To Next Page
Loading...
