instruction for the service people
22
ALARMS
The display show:
A2 probe (1...7): temperature over 105°C or probe in short circuit
A3 probe (1...7) not connected
LOADING AND UNLOADING OF THE MACHINE
For the transportation of the machine from the delivery point to the final installation position,
use a fork lift or adequate lifting equipment used by authorised staff. Lift the machine by its
frame, taking care that any protruding parts are not damaged (discharges, wiring etc.).
MACHINE DISMANTLING
At the end of its normal lifetime, the machine has to be taken apart according to the local
regulations in force by separating the components as follows:
• metal parts: hood, platforms, frames, filters
• electrical parts: motors, remote control switches, microswitches, wiring
• plastic parts: racks, connections
• rubber parts: tubes, sleeves
To Next Page
Loading...
