Comdel ESC-2/FP - B. Remote Manual Operation; C. Controls and Features; D. System Connections; E. Mechanical Specifications

ESC-2/FP Manual
C. Controls and Features
1. All control features are available local (front panel) and remote (25 pin d-type connector).
2. All analog set-point and monitor signals are available as 0-5v or 0-10v full scale and are fully differential.
Inputs are 200k ohm min. Outputs are capable of driving 1k ohm at 10v max.
3. All command lines and status indicators are uncommitted optically isolated digital signals. (All signals are
active true).
4. Continuously variable output voltage set point.
5. Continuously variable output current limit.
6. Hi-voltage enable command.
7. Hi-voltage enabled indicator.
8. Output polarity reversal command and disable.
9. Output discharge command.
10. Output voltage (differential) monitor.
11. Center tap voltage monitor.
12. Positive terminal output current monitor.
13. Negative terminal output current monitor.
14. Output protection: Active voltage and current limits in addition to 330k ohm output limiting impedance.
15. RS-232c Serial Interface for all remote control functions.
D. System Connections
Description Specifications
DC power input: 3 pin Molex type, non reversible quick disconnect. Molex P/N -
Consult Factory
DC output: MHV connectors for HV+ and HV-, BNC connector for HV-CT
Remote interface: 25 pin D-type female (DB-25f)
Fusing Requirements: 1Amp 3ag or equivalent
E. Mechanical Specifications
Description Specifications
Size: 8" W x 3.25" H x 6.25" D approx.
Weight: 2 lbs. approx.
Cooling: Free air
F. Environmental Specifications
Operating Temperature & Humidity
Operating ambient temperature:
0 to 45° C
Humidity: 10-90% non-condensing
Storage and Transportation
Storage temperature/humidity/air pressure:
0 to +70° C
© 2006 Comdel, Inc.
8