INSTRUCTIONS FOR TECHNICAL PERSONNEL
13
6) LOADING AND UNLOADING OF THE MACHINE
For the transportation of the machine from the delivery point to the final
installation position, use a fork lift or adequate lifting equipment used by
authorised staff. Lift the machine by its frame, taking care that any
protruding parts are not damaged (discharges, wiring etc.).
7) MACHINE DISMANTLING
At the end of its normal lifetime, the machine has to be taken apart according
to the local regulations in force by separating the components as follows:
• metal parts: hood, platforms, frames, filters
• electrical parts: motors, remote control switches, microswitches, wiring
• plastic parts: racks, connections
• rubber parts: tubes, sleeves
ENERGY CONSUMPTION
Model
(l)
Rinse water
consumpt.
(l)
Tank
heater
(W)
Rinse
heater
(W)
Wash
pump (W)
Total
electric
load (W)
Output in
racks per
hour with
55°C inlet
water
Output in
racks per
hour with
12°C inlet
water
RF321
21 3.5 2000 2400 450 2850 24 10
In the event of low water supply temperature, the will be a subsequent
machine output drop.
To Next Page
Loading...
Need help?
General
