INSTRUCTIONS FOR THE USER
6
6. Remove the rack and slightly incline it to permit a perfect drain; allow
dishware to dry and after having washed one’s hands, handle the rack in
order not to touch the dishware inside then place the rack on hygienically
clean shelves.
7. At the end of washing, open the door, empty out the tank by taking out the
overflow tube, then close the door for a few minutes to wash the machine.
Then again put the switch "Q1" in position "GREEN" and wait until the tank
is completely empty.
Machines with drain pump, with switch "Q1" in position "RED" and the
door open, simply push the "S3" button (for 3sec.) for the drain cycle,
automatically the machine will carry out the drain cycle for 2 minutes and 20
seconds. The "H3" lamp is on. At this point, the tank filter can be taken out,
in order to be washed, then replace it with the overflow in its place.
(For further use , first switch off the machine).
For any further information concerning equipment cleaning, read chapter
"USEFUL SUGGESTIONS".
8. When the washing is finished, switch off the equipment by
turning off the main supply through the general wall switch and close
the water supply.
To Next Page
Loading...
Need help?
General
