Comet CRRC 81 ECO - Safety Devices

32
IDENTIFICATION AND WARNING LABELS
CAUTION
• If one or more labels should become damaged during use, contact the Manufacturer or SPECIALIST
TECHNICIAN
for replacement.
a) Wheelbarrow identication label.
The identication label (6) displays the wheelbarrow model, year of manufacture and the main technical
specications.
It is located on base g. 7 (CRRC 51 ECO on frame g. 8).
b) CBM module identication label.
The CBM module identication label displays the model of the module, serial number, main technical
specications, and year of manufacture. It is located on one side of the module (front of tank) in proximity
of the inlet of the supply hose.
c) Machine’s technical data CE plate.
The CE plate (29) shows the wheelbarrow model, the year of manufacture and the main technical
specications, including the empty weight, tank capacity and full loading weight. It must be applied on a
clearly visible part of the base (9) (CRRC 51 ECO on frame g. 8) by the SKILLED TECHNICIAN.
d) Warning label.
The warning label (11) draws the user's attention to a number of hazards that may arise when using the
machine. It is located on the tank (14). The meaning of the pictograms is shown in the table below:
a.
No smoking
h.
Toxic substances
b.
Read the instruction manual
i.
Corrosive substances
c.
Do not stand within the operational range
of the machine
l.
Wash hands following each use
d.
Do not discharge waste into the environment
m.
Use gloves
e.
Do not remove safety devices
n.
Use safety mask
f.
Do not clean and lubricate when in operation
o.
Use ear defenders
g.
Do not drink! Non-potable water
p.
Use protective clothing
e) Symbol .
This appliance is marked with a symbol for separate collection of electrical and electronic equipment (WEEE).
This means that this product must be taken to a separate collection point in accordance with European
Directive 2002/96/EC in order that it can be recycled or dismantled to reduce its potential impact on the
environment.
Contact your local or regional council for further information.
Electronic products that are not separately collected are potentially harmful for the environment and
human health due to the presence of hazardous substances.
SAFETY DEVICES
a) Pressure switch.
This device, calibrated by the Manufacturer, allows the maximum operating pressure to be limited,
preventing dangerous pressures from occurring when shutting o the delivery line or when attempting
to set pressures above maximum permitted values.
CAUTION
• The pressure switch is calibrated by the motor pump Manufacturer. Do not recalibrate .