Comet Professional Series User Manual

⑱ Supply the steam by means of the gun lever;
⑲ Supply the detergent product by pressing the
red push button situated on the gun left side
together with the steam supply lever: no eect
will be produced by pressing just the push-
button.
WARNINGS
- For any eventual regulation, setting or parts
replacement not foreseen in this manual,
please contact the Manufacturer or Seller’s
personnel.
- Before carrying out any replacement make
sure that:
① the main switch is “OFF”.
Filling the tanks with water and detergent
Fill the tanks with water and detergent in the
following way:
① Stop the machine by turning the main switch
to OFF
⑭ ⑮ Fill the tanks
WARNINGS
- Never use distilled water! The machine may not
run correctly.
Water pipe supply from the water main
.
- Fit lter
⑰ at water inlet ⑯ .
- Connect a supply exible hose
⑯ (not included
in the supply) to the device water inlet
- Open water supply tap.
Note: The tank is provided with a oat that
prevent water infeed when the tank is full.
Water tank drain
- Close water supply tap
- Disconnect water supply hose from lter.
- Loosen drain plug (located under the tank).
Note: pay attention not to lose the plug seal.
- Empty the tank
- Screw the plug with its seal.
Boiler steam blow-o
Follow the instructions below:
⑤ A few minutes before the end of the work
shift, turn o the boiler by pressing the BOILER
START luminous green push-button.
⑨ Keep on using the steam gun until the pressure
gauge indicates a value of 0-1 BAR;
⑬ Carefully open the boiler drain tap situated on
the machine right side and drain all the water
from the boiler into a suitable container;
⑬ Once the water has been drained up
completely, close the tap;
MACHINE USE
Description of the start sequence
After carrying out all the connections and the
preventive inspections described in the previous
chapters, start the machine according to the
following instructions:
1) ⑤ Before starting the generator, ll the tanks
up to the level with water and detergent.
2)
⑨ Turn the main switch situated on the control
panel to ON.
3) Press the BOILER START push-button on the
control panel board.
4) Press the GUN START push-button on the
EN
23

Comet Professional Series Specifications

General

Brand	Comet
Model	Professional Series
Category	Vacuum Cleaner
Language	English