9
Ⅴ
ⅤⅤ
Ⅴ. Maintenance
Wire rope Replacement
Never use a wire rope of a different size or material and only use genuine
replacement parts.
The wire rope end is inserted through a hole in the drum and an allen set screw is
sued to clamp the wire rope in place. This rope attachment is simple and
ingenious.
1). Disengage the free-spool T-handle (Fig6)
2). Spool the entire wire rope, and then remove it from the drum.
3). Place the replacement wire rope through the fairlead opening, pass below the
drum, and insert it into the hole on the drum core. (Fig7)
4). Tighten the screw downwards to secure the wire rope (Fig7).
5).
5). 5).
5). The paints red markings on the wire rope to indicate 3 meters should remain on
the drum.
(Engaged) (Disengaged)
(Fig 6) (Fig 7)
Brake adjustment
When the brake wears to the point that the load begins to slip. The brake can be
adjusted as follows:
1). Loosen the bolt on the brake cover and take out retaining rings
2). Insert few washers to maintain the brake spacer between to be 2.2 ±0.25 mm
3). Make sure to keep the free-spool base plate counter-clockwise by 150 – 180
degree
To Next Page
Loading...
