2G:CO M F...2 G- 2G
5G:CO M F...5 G- 5G
N e t wo r k :Unav ail ab l e
Users：1
AP
Rou t e r
Rep eat er
3.5. Routing mode setting: Enter the software management page, only the
routing mode is displayed, click the routing mode, and you can choose
three Internet access modes: "PPPoE", "Static IP" and "Dynamic IP".
1, PPPOE dial-up mode: In this mode, you need to fill in the Internet
account and password provided by the network service provider. The
2.4G/5.8G wireless SSID name and wireless password can be set below.
2, Static IP mode: In this mode, you need to fill in the IP address, subnet
mask, gateway, and primary DNS address provided by the network service
provider. The 2.4G/5.8G wireless SSID name and wireless password can
be set below.
3, Dynamic IP mode: In this mode, the WAN port can only access the
Internet by assigning IP to the upper-level network device. The 2.4G/5.8G
wireless SSID name can be set below.
4. IPV6 setting: Support DHCPV6 client, static IP and Relay function, the
DHCPV6 client function is enabled by default.
To Next Page
Loading...