Why is my COMFORT-AIRE Comfort-Cire PAD-91 Air Conditioner not operating?
If your COMFORT-AIRE Air Conditioner isn't operating, first ensure the plug is correctly plugged in. Also, check if the fuse is blown or the protector tripped; wait 3 minutes and try again, as the protector device might be preventing the unit from starting. Finally, check if the batteries in the remote controller are defective.
What to do if COMFORT-AIRE Comfort-Cire PAD-91 Air Conditioner is operating but not cooling?
If your COMFORT-AIRE Air Conditioner is operating but not cooling, several factors could be responsible. Check if any doors or windows are open, or if a heating appliance like a heater is running in the same room. Ensure the air filter is clean and that neither the air discharge nor the inlet hose is blocked. Also, verify that the set temperature isn't too high.
What to do if COMFORT-AIRE Comfort-Cire PAD-91 Air Conditioner stops operating and water full indicator lamp lights up?
If your COMFORT-AIRE Air Conditioner stops operating and the water full indicator lamp lights up, pull out the rubber plug to drain the water. If this occurs very frequently, contact the dealer.
General| Brand | COMFORT-AIRE |
|---|---|
| Model | Comfort-Cire PAD-91 |
| Category | Air Conditioner |
| Language | English |
Cools, dehumidifies, and filters room air, maintaining desired temperature.
Re-circulates and filters room air, maintaining constant air movement.
Adjusts indoor fan motor speed using the remote controller's FAN SPEED button.
Increases or decreases set temperature by 1°F using UP/DOWN buttons.
Automates unit operation ON/OFF at preset intervals for comfort and energy saving.
Manages compressor and fan speed based on room temperature for efficiency.
Preset temperature 66°F-88°F; ambient cooling 64.4°F-109.4°F.
Indoor 80°F/67°F DB/WB; Outdoor 95°F/75°F DB/WB.
Indoor 20°C/Max.15°C; Outdoor 7℃/6℃ DB/WB.
Graphs showing cooling capacity, power input, and outlet air temperature vs. outside air temp.
Electrical schematic for the PAD-91 and PAD-121 portable air conditioners.
Electrical schematic for the PAD-121-E portable air conditioner.
Activates or deactivates the air conditioning unit.
Cycles through operation modes like COOLING, DRY, FAN ONLY, and SMART.
Allows selection of fan speeds: Automatic, High, or Low.
Adjusts the desired room temperature or timer settings.
Controls the direction of the airflow by adjusting louvers.
Engages intelligent fuzzy logic operation regardless of current unit status.
Sets or cancels the automatic ON timer for the unit.
Sets or cancels the automatic OFF timer for the unit.
Initiates or stops rapid cooling for quick temperature reduction.
Explains the icons displayed on the remote controller's LCD for status and signals.
Diagram illustrating the refrigerant flow in a cooling-only appliance.
Diagram showing refrigerant flow in a heat pump system with a 3-way valve.
Lists included accessories like air hoses, adapters, and slider kits.
Instructions for fitting the window kit to standard vertical and horizontal windows.
Guidelines for optimal placement, considering air circulation and obstacles.
Notes on hose routing, condensate management, and unit operation.
Steps for starting the unit, including location, hose setup, and power connection.
Advice on reading the manual, testing operation, and fuse specifications.
Diagnoses for issues like unit not operating, short operation, or poor cooling.
Detailed illustration of the internal components for PAD-91 and PAD-121 models.
Detailed illustration of the internal components for the PAD-121-E model.
Comprehensive list of replacement parts with part numbers for PAD-91 and PAD-121.
Comprehensive list of replacement parts with part numbers for PAD-121-E.
To Next Page