Operation of the Bed
FOR BEDS OPERATING WITH A CORDLESS HANDSET
This system incorporates a handset that does not have a lead to the motor and uses radio wave
technology to communicate between the operating handset and the bed motor. The handset for
the cordless system will look similar to the one shown in the picture below.
Operation of the bed
The diagram of the handset describes the function of each button.
Please take a few moments to acquant yourself with its features.
Handset
6
Should you experience any operating problems with your bed, please check the following:
Trouble shooting
1. Check the plug is firmly in the wall and that the socket is switched on.
2. Check that the wall socket works by plugging in another working
appliance i.e a table lamp
3. When the bed is commisioned by us, we have to synchronize the
operating handset to the motor to ensure it has its own radio frequency to operate with.
It is posible that this connection can be lost, i.e if you suffer a prolonged power cut for
example. In this scenario, please follow the steps below to re-establish the connection:
1. Unplug the bed from the mains electrical socket
2. Remove the batteries from the bed motor
3. Leave for approximately 30 seconds
4. Plug back into the electrical socket, but do not switch the power on
5. Press buttons S7 and S8 simultaneously until the light on the handset flashes
6. Switch the electrical power on at the wall and you will hear a beep from the motor.
7. Reconnect the batteries in the motor
If you have any problems, please contact our customer service department on 01462 678050
To Next Page
Loading...