9
Additional Options Explained
If purchased, the following may be applicable (Only available on cordless beds) :
Underbed Lighting strip
Underneath the bed may be fitted a “lighting strip” when the underbed lighting strip button (S3) see
page 7 is pressed on the cordless handset, the strip will light the floor at the side of the bed to help with
getting out of the bed in the middle of the night. This feature is designed for use in a dark room, the light
may not be visible in an already lit room. To switch off the light, press the same button (S3) on the cord-
less handset.
In the event of the lighting strip not working, please ensure the lead running from the strip under the bed
is connected firmly to the motor of the bed.
Lamp Box Unit
Supplied with the bed is a separate Lamp Box Unit which enables a bedside lamp to be plugged into
the box which can then be operated from the cordless handset control using the “S2” button see page
7. The lamp and lamp box unit can be positioned anywhere in the room.
In the event of the lamp box unit not working, please complete the following :
1.Unplug the lamp from the lamp box unit.
2.Plug the lamp directly into a wall socket and switch the lamp to the “on” position ensuring it lights up.
3.Unplug the lamp from the wall, DO NOT switch the lamp “off”.
4.Ensure the lamp box unit is firmly plugged into the wall socket and the power is switched on.
5.Plug the lamp back into the lamp box.
6.Press buttons S7 and S8 simultaneously on the control handset until the light on the handset flashes.
7.Locate the red slide switch on the Lamp Box Unit, slide the switch one way, then slide it back again.
8.The light on the handset should stop flashing, and the lamp can now be operated from the control
handset using button “S2”.
To Next Page
Loading...