Need help?Do you have a question about the Comm-Tec EIB and is the answer not in the manual?
Explains the purpose of the software module connecting AVIT/AMX control systems to the European Installation Bus (EIB).
Emphasizes the critical importance of solid EIB knowledge and close contact with experienced EIB installers.
Compares EIB to AMX systems, explaining bus topology, decentralized structure, communication via telegrams, and address types.
Discusses how the CTG-KNX/IP gateway interacts with the EIB bus, including considerations for line couplers and telegram filtering.
Details the physical connections (230V, EIB), LEDs (Busspannung, Telegramm, TX, RX, Betrieb, Prog-LED), and the programming push-button.
Covers the installation process, including connecting the gateway to the network via a standard TCP/IP interface.
Guides on obtaining the gateway's IP address and integrating the module using a virtual device for communication.
Describes how to analyze feedback signals within a Data_Event, noting one event is released per feedback signal.
Details the module interface, available commands (ADD, DATE, DEBUGON, EIS5, GET, POLL, SET, TIME, UPLOAD, VERSION), feedback types, and terminal mode functions.
Discusses the structure and generation of the EIB table, including recommendations for editing and poll trigger entry.
Recommends using EIB_Tools.AXI functions for programming, covering sample programs like EIB table structure and loading from file.
Details changes in filter table generation, comparing previous SEND_COMMAND syntax with new EIBAdd function.
Explains the evolution of actuator control commands, comparing SYSTEM_CALL with new EIBSet and SEND_COMMAND SET.
Describes the new feedback mechanism using a single array and outputting raw data as ASCII strings.
To Next Page
General