10 of 29
The On Screen Display can be switched on or off.
• Select Switches
Before powering on the ProPLAY:
• Make sure the corresponding signal cables have been connected from
the Composite, S-Video or graphic output jacks. In case of graphic output
use, don’t connect a S-Video cable to the unit.
• Set the 'PAL/NTSC' switch to the chosen output format.
• Set the ‘Graphic/Video‘ according to the output you have connected.
• Power Up
The Autoplay and Sleep playback mode are selected when writing the MPEG
files on to the CompactFlash Card by using ProPLAY Studio software.
Auto-Play start up mode
• Plug in the external power supply
• Insert CompactFlash Card containing ProPLAY Studio exported “.pll /
.prj” and other digital files. (e.g. .mpg, .jpg) All filenames should be in 8+3
format (i.e. xxxxxxxx.xxx) and avoid using any illegal characters like “~”,
“_”, “-“, etc
• Switch the power 'on/off' switch to 'on'.
• The first track of the collection of MPEG files will be auto-played.
Sleep mode
• Plug in the external power supply
• Insert CompactFlash Card containing ProPLAY Studio exported “.pll /
.prj” and other digital files. (e.g. .mpg, .jpg) All filename should be in 8+3
format (i.e. xxxxxxxx.xxx) and avoid using any illegal characters like “~”,
“_”, “-“, etc
• Switch the power 'on/off' switch to 'on'.
• Press the 'play' button'.
• The first track of the collection of MPEG files will be played.
Special specific track playback activated by assigned button can also be
performed in sleep mode using ProPLAY Studio software.
Auto-Loop Playback
After Track 1 is set to play, it will play to the end, then Track 2 will start playing from
beginning to end, then Track 3 etc. When the ProPLAY plays to the end of the last
track, it will automatically jump back to the beginning of Track 1, repeating tracks 1,2
then 3 etc. The ProPLAY will play in auto-loop play mode, so long as none of the
function buttons are pressed. Loop playback is the standard playback setting of the
ProPLAY (in simple play and playlist mode) but the track playback sequence can be
changed as required using ProPLAY Studio software.
To Next Page
Loading...