5
2. Door release card registration/deletion
1) Card registration
(1) On tagging the master card for registration, LED slowly flickers with beep sound.
(Entering registration mode).
(2) Beep sound comes out when door release card is tagged.
(3) In case more than 1 cards have to be registered, repeat above (2) procedure.
(4) Press button 3. when the registration finish.
2) Individual Card deletion
(1) LED flickers fast on tagging master card for deletion. (Entering Pre-Deletion mode).
(2) Press button 3. Then beep sound comes out. (Entering Individual deletion mode)
(3) After tagging the card which need to be deleted, LED flickering and beep sound stops.
(4) Repeat (1)~(3) procedure to delete other cards.
3) All cards deletion
(1) On tagging the master card for deletion, LED flickers fast
(Entering Pre-Deletion mode).
(2) Press button 3.(5seconds). Then, LED flickers faster with beep sound.
(Entering All cards deletion mode)
(3) Tag master card for deletion again. Then, LED gets turned off and all cards deletion will be processed.
After all cards information deleted, LED gets turned on with beep sound.
Remark
1) Maximum 2,046 cards can be registered.
2) In case of exceeding card registeration memory, beep sound comes out for 1.5 second.
3) Press button 3. to escape from registration/deletion mode while processing registration/deletion process.
4) Do not turn off the device until all cards deletion process is completed.
To Next Page
Loading...
Need help?
General
