Commodore Amiga - Page 77

Moving a Tool, Project, or Drawer to a New Disk
To move a copy of a tool, project, or drawer to a new disk, open the disk you
want
to move it to, then drag the icon into the window for the disk.
Renaming Disks
To rename a disk, select the icon for the disk, then choose Rename from the
Workbench menu. A message then appears asking you for a new name .
Select
the window that appears, type in a name, then press the RETURN key.
Resetting the Workbench
Resetting the Workbench means to set it up again. When you do, you start
again with only the Workbench, and the Amiga's memory is cleared. If a
tool malfunctions, you may be forced to reset before you can resume work.
To reset the Workbench, hold down the CTRL key and both Amiga keys at
the same time for at least half a second, then release the keys.
WARNING: Always make sure the disk drive lights are off before
resetting the Workbench.
Other Workbench Operations
There are five other tasks you perform on the Workbench. You choose each
task-straightening up the Workbench icons, displaying the last error
message, redrawing the display, saving the positions of icons and windows,
and showing the internal version number of the Workbench-from the
Special menu for the Workbench.
Cleanup
If a drawer is open and the icon you selected to open the drawer is currently
selected, choosing Cleanup straightens up icons in the drawer.
4-32 Using the Workbench