Commodore Amiga - Page 94

Baud Rate
If you have an add-on connected to the serial connector of your Amiga, you
can change the baud rate-the rate at which information is transferred
through the serial connector-by selecting the arrows below and to the right
of the words Baud Rate. The current baud rate is shown to the left of the
arrows. Select the up arrow to increase the baud rate. Select the down
arrow to decrease the rate.
Workbench Colors
With Preferences, you can change any of the four colors displayed by the
Workbench. Start by selecting the color you want to change from the four
colors shown. Below these colors are three sliders labeled R, G, and B.
These letters stand for red, green, and blue, the colors that the Amiga
combines to create the colors it displays. To mOdify the color you've
selected, you change the amount of red, green, and blue in the color by
dragging
the arrows along the sliders.
Try dragging the arrows in the sliders and watch how the color changes.
With a bit of practice, you'll be able to get the colors you want .
To get back the colors you had before you opened Preferences, select the
gadget labeled Reset Colors. (To get back the original Workbench
colors-the ones displayed when you inserted the original Workbench disk
that came with the Amiga-select the Reset All gadget described below.)
Changing the Pointer
To learn how to change the Pointer with Preferences, see Appendix C,
"Changing the Pointer ."
Reference 7- 5