Commodore PC - Page 127

n
n
n
n
Exit
Purpose:
Exits the command.com program (the command processor) and
returns to a previous level, if one exists.
Syntax:
exit
Comments:
If you use the msdos command program to start a new command
processor, you can use the exit command to return to the old
command processor. Also, while running an application program,
you can exit to the msdos command processor, and then return to
your program.
Refer to the command command in this chapter for more
information.
Example:
If you start a new command processor by typing the following
command, you can then return to the previous command proces
sor by typing the exit command:
command c:V
MS-DOS Commands 55
Exit
i
n