Commodore PC - Page 133

n
Graftabl
i» Purpose:
Loads additional character data into a table in memory for use
>*-v with a color or graphics adapter.
Syntax:
graftabl
Comments:
Graftabl loads a table of the ascii characters, 128 through 255,
into memory. If you have a color or graphics adapter, this table
lets you display foreign language characters when you are in
graphics mode.
After graftabl loads the character table, it displays the following
message:
GRAPHICS CHARACTERS LOADED
You can load the graphics table only once each time you start
MS-Dps. If you try to load the table a second time, graftabl
displays the following message:
GRAPHICS CHARACTERS ALREADY LOADED
Note This command increases the size of ms-dos resident in
memory.
Example:
To load the graphics table into memory, type the following:
graftabl
MS-DOS Commands 61
Graftabl
Loading the graphics
table into memory