Commodore PC - How to use the Debug command parameters

210 MS-DOS User's Reference
Debug command
Function
U
A [address]
C range address
D [range]
E address [list]
F range list
G [= address [address...]]
H value value
I value
L [<z*ft/ress [drive-record record]]
M rawge address
N filename [filename]
Q
R [register-name]
S range /&/■
T [ =<zdtfress] [value]
U [range]
W [address [drive-record record]]
Assemble
Compare
Dump
Enter
Fill
Go
Hex
Input
Load
Move
Name
Output
Quit
Register
Search
Trace
Unassemble
Write
U
u
U
U
-
U
how to use the Debug Debug Command Parameters
command parameters
All debug commands accept parameters, except the Q (quit)
command. Parameters may be separated by delimiters (spaces or
commas), but a delimiter is required only between two consecu
tive hexadecimal values. Thus, the following commands are
equivalent:
dcs:100110
d cs:100 110
d,cs:100,110
U
U
U
U