Commodore PC - Page 361

F—I2B9
Incorrect DOS Version
[Append][Attrib][Backup][Chkdsk][Diskcomp][Diskcopy]
f0^) [Edlin][FC][Find][Format][Graphics][Join][Keyb^]
[Label][Mode][More][Print][Recover][Replace][Restore]
[Share][Sort][Subst][Sys][Tree][Xcopy]
f**^ ■ Some ms-dos utilities will not run on older versions of the
operating system, and many are written to run only on the
exact version of ms-dos that they were created for.
/-—s You must use the correct version of ms-dos to run this
command.
Incorrect number of parameters
O [Join][Subst]
■ You specified either too many or too few options in the
command line.
Incorrect parameter
[Assign][Share]
^- ■ One of the options you specified is wrong.
Infinite retry on parallel printer timeout
[Mode]
^"^ ■ Your printer is probably off-line or not ready.
If the printer appears to be ready, you may have to press the
control-alt-del keys to reset the computer.
Insert backup diskette n into drive x:
[Backup][Restore]
^^ ■ This message prompts you for the nth backup disk.
( ^ Put the next disk into the specified drive. Be sure to label each
backup disk in the appropriate order for use when restoring the
files.
Insert destination disk in drive x:
and strike any key when ready
■ This message appears when you are using Sys to transfer the
operating system with a single disk drive.
s—*. You should insert a disk in the appropriate drive and press any
f > character or number key to begin processing.
Insert diskette for drive x:
(~*\ and strike any key when ready
[MS-DOS]
■ This message appears when ms-dos is copying and formatting.
/"-^ You should insert a disk in the appropriate drive and press any
character or number key to begin processing.