Commodore Plus 4 - Page 201

SYNTAX T oddress 1 > oddress 2> oddress 3>
oddress 1 > Starting address of data to be moved
.' i /fess 2 > Ending address of data to be moved
<-address 3> Starting address of new location (where the data will go)
Data can be moved from low memory to high memory or vice-versa.
Additional memory segments of any length can be moved forward or
backward any number of bytes (i e . shifted).
EXAMPLE T 1400 1600 1401
Shifts data from SI400 up to and including S1600 one byte higher
in memory.
COMMAND V (VERIFY)
PURPOSE Verify a file on cassette or disk with the memory contents.
SYNTAX V <"filename'">, <devlce>
■ filename > is any legal Plus/4 filename.
■■-device > is a hexidecimal number indicating which device the tile is
on; cassette is 1 or 01. disk is 8 or 08, 09, etc.
The Verify command compares a file to memory contents. The Plus/4
responds VERIFYING. If an error is found, the word ERROR is added;
if the file is successfully verified, the flashing cursor reappears.
EXAMPLE V-WORKLOAD11. 8
— COMMAND. X(eXit)
PURPOSE Exitto BASIC
SYNTAX X
— When the X command is given, the machine stack pointer is set to the
current stack pointer value (see the R command). If this is modified in
any way. after exiting to BASIC use the BASIC CLR commanc to reset
the pointers
—