Commodore Plus 4 - Page 202

SECTION 6
Screen
Display
Codes
llowing chart lists atl of the characlers built into the Commodore
character sets It shows which numbers should be POKEd into screen
memory (locations 3072 to 4095) to get a desired characler. (Remem
ber to set color memory - 2048 to 3071) Also shown is which char
acter corresponds to a number PEEKed from the screen
Two character sets are available, but only one set at a time. This means
that you cannot have characters from one set on the screen at the
same time you have characters from the other set displayed The
sets are switched by holding down the IBBBH and SHU keys
simultaneously.
From BASIC. PRINT CHRS(142) will switch to upper-case/grapnics
mode and PRINT CHRS{14) switches to upper'lower-case mode
Any number on the chart may also be displayed in REVERSE The
reverse character code may be obtained by adding 128 to the
values shown.
_
_
_
193