3.0 Device Search
After connecting the controller and the device, start the controller software, then conduct the
1.
device search.
2. From the Main Screen, click on the
Find Devices
button to initiate the device scan (Figure 3-1).
Figure 3-1. Main Startup Screen Ready for Device Search.
3. Device search in progress (Figure 3-2).
Figure 3-2. Progress Shown During Device Search.
639585
Page 6 of 8
www.commscope.com
© 2016 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639585 C (05/16)
To Next Page
Loading...
Need help?
General
