3. After completing required firmware updates, the application will begin gathering all information on
devices attached to the bus.
Figure 4-3. Device Firmware Update is Complete.
After the firmware update, the version can be checked by selecting an actuator device and clicking
on the
Get Device Info
button (Figure 4-3). Check to verify that the version showing is the desired
version (Figure 4-4).
Figure 4-4. Device Information.
639585
Page 8 of 8
www.commscope.com
© 2016 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639585 C (05/16)
To Previous Page
Loading...
Need help?
General
