8
1
11
13
12
Bottom Mount Installation
M10 screw
M10 pivot screw
center location
(loosen only)
M10 pivot screw
(loosen only)
M8 adjuster screw
perimeter location
(remove to adjust tilt)
M10 pivot screw
(loosen only)
M10 pivot screw
(loosen only)
M10 pivot screw
(loosen only)
DETAIL D
•
Loosen pivot screws . (do
not remove)
• Remove adjuster screws.
• Adjust antenna angle.
(use inclinometer)
• Reinstall adjuster screws.
• Retighten all screws.
Adjusting Antenna Tilt - 2 POINT MOUNT
(Not applicable for BSAMNT-F)
use inclinometer to
adjust antenna angle
9 10
WARNING
: LOOSENING OR REMOVING BOLTS
THAT ATTACH MOUNTING PLATE TO ANTENNA
WILL VOID WARRANTY AND MAY RESULT IN
PRODUCT DAMAGE OR PERSONAL INJURY.
D
19
C
DETAIL C
MAXIMUM TORQUE
M10
40N.m (30ft.lbs)
M12
58N.m (43ft.lbs)
MAXIMUM TORQUE
M8
25N.m (18ft.lbs)
M10
40N.m (30ft.lbs)
M12
58N.m (43ft.lbs)
639840
Page 3 of 4
www.commscope.com
© 2020 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639840 J (02/20)
To Next Page
Loading...