SYSTIMAX
®
Solutions www.commscope.com
Instruction Sheet 860344274
Issue 10
, October 2019 Rev B
SYSTIMAX
MGS Module Termination Instructions
© 2012 CommS
cope, Inc. All rights reserved
Page 1 o
f 5
General
These instructions provide the recommended termination procedure for all SYSTIMAX
®
MGS-type modules.
MGS600 modules are illustrated here, but instructions also apply to MGS400 and MGS500 modules. The MGS
modules are UL approved. Preparation of the new SYSTIMAX GigaSPEED
®
X10D 91B series cable, 95B
series cordage, or 91SD series cable is also shown. For complete instructions on prepping the
GigaSPEED X10D 91B series cable, 95B series cordage or 91SD cable for termination, see instruction
sheet 860 469 402. Refer to the SYSTIMAX X10D Design and Installation Guidelines for further
information.
The following tools are available to aid in module termination.
Material ID
Description
D-914 kit - includes impact tool and 110 blade
D-914 impact tool only
Replacement 110 blade for D-914 impact tool
Module removal tool (quantity of 5)
Hand termination tool (hand puck)
How to Contact Us
• To find out more about CommScope
®
products, visit us on the web at http://www.commscope.com/
• For technical assistance:
- Within the United States, contact your local account representative or technical support at
1-800-344-0223. Outside the United States, contact your local account representative or Authorized
Business Partner.
- Within the United States, report any missing/damaged parts or any other issues to CommScope
Customer Claims at 1-866-539-2795. Outside the United States, contact your local account
representative or Authorized Business Partner.
Preparation of X10D 91B Series Cable, 95B S
eries Cordage, or 91SD Series Cable
for Termination
This pr
oduct is covered by one or more of the following U.S. patents : 5.997.358 / 5.1.86.647 / 5.897.395
Pull flute and tapes
off to one or more sides
Unwind separator tape
Pull o
f
f to the side so that it can
be trimmed close to the jacket
To Next Page
Need help?
General