commtech wireless 7950 Quick Guide

THE 7950 PAGER
1.1 Case Layout
1.2 Hand Programming Menu
 With the pager turned on, hold down the Escape Key and Read Key for 3 seconds.
 You will be prompted for a four digit numeric password.
PASSWORD:0000
 Use the Escape Key to increase the selected digit and the Read Key to decrease the
selected digit. Press the Arrow Key to move along to the next digit. After the correct digits
are entered, press the Arrow Key to proceed to the first screen. By default this password is
0200.
 Once you are in the programming menu, you will see the first four cap codes ready for viewing or
editing. There are eight cap codes available in total. The A, B, C, D, E, F, G, H at the start of the line
corresponds to cap code 1 to 8.
A: [ ON] 0000008
B: [ ON] 0000016
C: [ ON] 0000024
D: [ ON] 0000032
 NOTE: If you just need to change frequency or baud rate and not any capcodes, you can press the
Arrow Key to jump to that screen.
 Each cap code can be enabled or disabled if required. This is what the ON or OFF field before each
cap code refer to.
 Use the Escape Key and Read Key to change the selected field. Use the Arrow
Key to move to the next field.

commtech wireless 7950 Specifications

Operating Environment

ambient temperature operating range	0 to 50°C (20-90% RH non condensing)
storage temperature range	-10 to 60°C (10-95% RH non condensing)
frequency stability	10ppm

Power

power supply	1 x AA battery 1.5 volts
nominal battery life	around 20-80 days depending on usage
beeper	75dBc SPL @ 30cm / 12inches

Display

lcd	Dot matrix with zoom function
lcd resolution	2 lines x 20 characters per line
lcd resolution (bold)	2 lines x 15 characters per line

Weight and Dimensions

dimensions	70 x 49 x 19 mm / 2.7 x 1.9 x 0.7 inches
weight	135 grams / 4.6 oz