commtech wireless 7950

To Previous Page

Manual Pager Hand Programming

Page 2 © CommtechWireless

 Once you have scrolled through all of the fields on this first screen, you will be taken to the

second screen which contains the next four cap codes.

E: [ ON] 0000008

F: [ ON] 0000016

G: [ ON] 0000024

H: [ ON] 0000032

 Once you have scrolled through all of the fields on this second screen, you will be taken to the

third screen which contains settings for the pagers baud rate, polarity and frequency.

BAUDRATE: 512 BPS

POLARITY: NORMAL

FREQ: 148.3375 M

PROGRAM EXIT

 Use the Escape Key and Read Key to change the selected field. Use the Arrow

Key to move to the next field. These settings must match that of your paging system.

 To save any changes you have made, move the cursor to the “Program” field and press the

Read Key. The screen will display EEPROM PROGRAMMING followed by **FINISHED**. The pager

will then resume normal operation with the newly programmed settings.

EEPROM PROGRAMMING

 To exit the programming menu without saving any changes, move the cursor to the “Exit” field

and press the Read Key. The pager will then resume normal operation.

commtech wireless 7950 - Page 2