ComNav 1101 Autopilot
For Compasses equipped with a Magnetic Sensor,
1. Watch the card on the Autopilot Compass to make sure that it
follows the vessel movements properly. If the card seems to
turn with the vessel for a few degrees and then sticks for a
while, either the pivot or the jewel in the compass needs repair.
Contact a ComNav dealer or the factory for assistance.
The Remote Control does not work.
1. Check the Remote in Command pip on the remote display to
see if the Remote is in control. If not, you may take control by
pressing the two DODGE buttons on the Remote.
2. Ensure that the Remote is plugged into the receptacle on the
rear of the SPU labeled Aux. Station.
9 - 5 PROBLEM SOLVING
To Next Page
Loading...
