ACPI CarBus Controller ENE CB1420
• ACPI-PCI Bus Power Management Interface specification Rev 1.1 Compliant
• Supports OnNow LAN wakeup, OnNow Ring Indicate, PCI CLKRUN#, and PME#, AND
CardBus CCLKRUN#
• Compliant with PCI specification v2.2, PC Card Standard 7.0 and JEIDA 4.1
• Yenta
TM
PCI to PCMCIA CardBus Bridge register compatible
• ExCA (Exchangeable Card Architeture) compatible registers mappable in memory and I/O
space
• Intel
TM
82365SL PCIC Register Compatible
• Supports PCMCIA_ATA Specification
• Supports 5V/3.3V PC Cards and 3.3V CardBus cards
• Supports single PC Card or CarBus slot with hot insertion and removal
• Supports multiple FIFOs for PCI/CardBus data transfer
• Supports Direct Memory Access for PC/PCI and PCI/Way on PC Card socket
• Programmable interrupt protocol: PCI, PCI+ISA, PCI/Way or PC/PCI interrupt signaling
modes
• Win’98 IRQ and PC-98/99 compliant
• D3
cold
state PME# wakeup support
• 3.3Vaux Power Support
• Integrated PC 98-Subsystem Vendor ID support, with auto lock bit
Floppy Disk Drive
• 3.5"1.44MB, 3 mode as an I/O module
Hard Disk Drive
• 2.5" up to 40 GB, 9.5mm height
CD-ROM Module
• 12.7mm height module
• CD-ROM, DVD, CDRW,COMBO
• 24X CD_ROM
Audio Port
MIC IN
• AC-coupled input,100mVP-P maximum
Line out
• 1V
P-P
Built-in Microphone
• Sensitivity-45dB
• S/N:58dB
Built-in Speakers
• 8Ω, 1W (resonant frequency 460HZ) speakerX2
Built-in Speakers
• 8Ω, 1W (resonant frequency 460HZ) speakerX2
Chapter 1-6
To Next Page
