7
OWNERS MANUAL
3
4
2
CONNECTION
Your appliance is designed to connect directly on to a POL gas cylinder
using the specially designed LP Gas hose and regulator supplied with
the appliance.
1
Step 1. Check that the Control Knobs are in the
“Off” position (turned fully clockwise).
Step 2. Take the stove connector head of the
hose and attach to the gas inlet on the
appliance, tighten using a spanner.
Step 3. Attach the other end of the hose to the
gas cylinder and tighten.
Step 4. Turn the cylinder gas valve on in an
anti-clockwise direction for one full
turn and then check the connections
for leaks with Companion Gas Leak
Detection Spray or soapy water. If a leak
is detected turn the cylinder gas valve
“Off” and retighten all connections,
then retest.
To Next Page