Desktop Management Guide www.hp.com 11
Desktop Management Guide
8. Turn on the computer to be configured.
9. As soon as the computer is turned on, press and hold the
F10 key
until you enter Computer Setup. Press
Enter to bypass the title
screen, if necessary.
10. Click File > Replicated Setup > Restore from Removable
Media, and follow the instructions on the screen.
11. Restart the computer when the configuration is complete.
Copying to Multiple Computers
Ä
CAUTION: A setup configuration is model-specific. File system corruption
may result if source and target computers are not the same model. For
example, do not copy the setup configuration from a dc7100 Ultra-Slim
Desktop to a dx6100 Slim Tower.
This method takes a little longer to prepare the configuration diskette
or USB flash media device, but copying the configuration to target
computers is significantly faster.
✎
A bootable diskette is required for this procedure or to create a
bootable USB flash media device. If Windows XP is not available to
use to create a bootable diskette, use the method for copying to a
single computer instead (see “Copying to Single Computer” on
page 10).
1. Create a bootable diskette or USB flash media device. See
“Supported USB Flash Media Device” on page 13 or
“Unsupported USB Flash Media Device” on page 16.
Ä
CAUTION: Not all computers can be booted from a USB flash media
device. If the default boot order in the Computer Setup (F10) Utility lists
the USB device before the hard drive, the computer can be booted from a
USB flash media device. Otherwise, a bootable diskette must be used.
2. Select a setup configuration to copy. Turn off the computer. If you
are in Windows, click Start > Shut Down > Shut Down.
3. If you are using a USB flash media device, insert it now.
4. Turn on the computer.
To Next Page
Loading...
Need help?
General
