Computer Setup (F10) Utility Guide www.hp.com 19
Computer Setup (F10) Utility
Advanced*
(continued)
Power-On Options
(continued)
Allows you to set:
• Option ROM prompt (enable/disable)
Enabling this feature will cause the system
to display a message before loading
options ROMs. (This feature is supported
on select models only.)
• Remote wakeup boot source (remote
server/local hard drive).
• After Power Loss (off/on): After power
loss, if you connect the computer to an
electric power strip and would like to turn
on power to the computer using the switch
on the power strip, set this option to “on.”
✎
If you turn off power to the computer using
the switch on a power strip, you will not
be able to use the suspend/sleep feature
or the Remote Management features.
• POST Delay (in seconds)
(enable/disable). Enabling this feature
will add a user-specified delay to the
POST process. This delay is sometimes
needed for hard disks on some PCI cards
that spin up very slowly; so slowly that
they are not ready to boot by the time
POST is finished. The POST delay also
gives you more time to select the F10 key
to enter Computer (F10) Setup.
*For advanced
users only.
Computer Setup (Continued)
Heading Option Description
✎
Support for specific Computer Setup options may vary depending on the hardware
configuration.
To Next Page
Loading...
