2–10 Software Guide
Security
Entering Administrator Passwords
At the Setup prompt, type your password (using the same type
of keys you used to set the password), and then press
enter. After
3 unsuccessful attempts to enter the Administrator password,
you must restart the notebook to try again.
Using Other Device Security
The Device Security feature also allows a user or administrator to
set the system startup preferences by enabling or disabling
notebook devices. To set system startup preferences in Device
Security:
1. Open the Setup utility by turning on (not restarting) the
notebook.
2. Press
F10 while the “Press <F10> to enter setup” prompt is
displayed in the lower left of the screen.
3. Select Security from the menu bar. (To select a menu, use the
arrow keys.)
4. In the Device Security field:
a. Select Enable/Disable floppy boot during boot time.
b. Select Enable/Disable CD-ROM boot during boot time.
5. To save your preferences and exit the Setup utility.
a. Press
esc (or select Exit from the menu bar).
b. Select Exit Saving Changes.
c. Then follow the instructions on the screen.
To Next Page
Loading...
