1-8 English
Part Number: 325803-002- Writer: Bruce Sullivan- Saved by: Bruce Sullivan
Pages: 13 Words: 2463 Saved date: 09/03/99 10:45 AM File Name:SonHogan
Adjusting Picture Quality
Allow the monitor to warm up for 30 minutes before performing the
following procedures. The picture image stabilizes after a warm-up
period.
Optimizing Contrast
For best results, set your screen to a dark background (such as the DOS
prompt) before adjusting the following settings:
1. Set the brightness and contrast controls to their lowest settings.
2. Increase brightness until the background portions of the screen
are visible, then slowly reduce brightness until the background is
just extinguished.
3. Adjust contrast control to your preference.
Optimizing Focus
The default image size is preset at the factory. The Size and Position
controls in the on-screen display can be used to increase the screen size
beyond the default setting. However, expanding the screen image
beyond the default settings may degrade the focus at the outer edge of
the screen.
To enhance focus, use the lowest brightness level that gives satisfactory
results in your viewing environment.
✎
Settings that maximize contrast may not offer optimum focus,
and settings that maximize focus may not offer optimum
contrast.
To Next Page
Loading...
Need help?
General
