V. Installation of the Aluminium Beam *
• You have to install the aluminium beam before you install the coping stones
around the pool.
• Dimensions aluminium beam: 110x65mm
• The aluminium beam has been anodised as an extra protection against
corrosion. Be careful not to damage or scratch the beam during the
installation.
• The aluminium beam has a SS bracket on each side to adjust its level.
• In the back wall behind the roller cover you install a skimmer with water
level controller.
• The cover pit can be covered with wooden or polypropylene grates.
• Chapter V.1: Installation sequence
(*) Only valid with COMFORT LINE
(*) Only valid with COMFORT LINE
To Next Page
Loading...