Compex LT - Operating Instruction; Recommended Practice

To Next Page

To Previous Page

OPERATING INSTRUCTION

RECOMMENDED PRACTICE:

• Electronic Pulse Stimulator (TENS)needs to be charged for up to 8 hours before the ﬁrst use.

• Connect a pair of electrode pads to one connecting wire by snapping them on; the other end of the connecting wire is connected

to the left output of the device. Similarly, the other pair of electrode pads is connected to the remaining connecting wire and the

right output of the device.

• Attach one pair or two pair of the electrode pads to the treatment area, such as shoulder and legs.

• Turn the unit switch on. When being on, the unit will automatically start at Mode 1.

• When being on, if the pad doesn’t stick to the skin, the word “PAD” on LCD will ﬂash and remind you to stick pads well. When

“PAD” is ﬂashing, you will not be able to increase the intensity.

• To change the mode press the M button, and gradually increase the intensity of the A (left) output by pressing the + button;

decrease the intensity by pressing the - button.

• When pressing the （ button, the unit will stop.

• When pressing T, one of the six timers could be selected.

• When pressing the B button once, switch from the control of the A(left) output to that of the B (right) output:

only the intensity of the B output could increase or decrease by pressing the + or - button. When pressing the A button again, switch

back to the A output; only the intensity of the A output could increase or decrease.

•Duration suggested for each skin area is 20 min and 2 times per day. Consult with your physician for longer and more frequent

uses.

•Start from the lowest intensity and gradually adjust the intensity to a comfortable level at a scale from 1 to 20.

•Good skin care is important for a comfortable use of device. Be sure the treatment site is clean of dirt and body lotion.

•Keeping the electrode in the storage bag after use will extend its lifespan. The electrode is disposable and should be replaced when

it loses the adhesiveness.

•When there is no bar inside battery icon and the battery icon keeps ﬂashing, the power is low and the device will power off after 15

seconds. Recharge before using.