Complete * Schaumburg, IL 60173 * Phone: 888-392-9947
10
TROUBLE SHOOTING
Defective piston ring (worn or
broken)
Defective inner surface of cylinder
(worn or rough)
Disassemble the output unit and
check the inside and outside
surfaces of the piston ring and
cylinder
Replace the defective parts
Staples clog within
the ejecting gate
Staples are inaccurately fed into the
blade guide
Incorrect Staples are loaded
Refer to first item
Refer to first item
Use designated staples
Worn tip of the driver blade
Carry out idle driving and check if
blade tip if worn or not
Replace
Worn guide groove of the blade
guide
Check the wear of the blade guide Replace
Work piece material is too hard
Stop using the tool
Failure Possible causes Check Method Counter measures
The driven staple
is bent
Staples are inaccurately fed into the
Blade Guide
Incorrect staples are loaded
Refer to item above Refer to item above
Worn driver blade
Check if the driver blade is
extremely worn or not
Replace the driver blade
The wood is too hard
Check if the nails bend on softer
wood or not
Stop using the tool
The driven staples
do not fully
penetrate the work
piece (heads
protrude)
The wood is too hard
- Stop using the tool
Air pressure too low
- Adjust the air pressure
Worn or broken driver blade
Carry out idle driving and check
if the driver blade protrudes
from the blade guide nose
Check if the tip of the driver
blade is excessively worn or not
If the driver blade does not protrude
from the blade guide replace
Incorrect driving depth adjustment
Adjust the guide plate to the
appropriate position.
To Next Page
Loading...
