PM200/PMH200/PME200/PML200 (07/98) PM200/PMH200/PME200/PML200 (07/98)
Introduction
This Installation and Service Information booklet is intended for persons (electrical engi-
neers, service technicians) authorised to install and service the camera. These persons
must be familiar with all the regulations relating to electronics and must comply with
these regulations at all times. This information is not suitable for users without specialist
knowledge.
Intended use
The PCB cameras PM200, PMH200, PME200 and PML200 are system components
for professional use in closed-circuit surveillance systems. Other applications are not
permitted.
The cameras should be installed and serviced only by qualified electrical engineers.
In the event of questions concerning the use of the camera modules which are not ans-
wered in this information booklet, please contact:
CBC (Europe) Ltd
Via E.Majorana, 2
20054 Nova Milanese (MI)
Italia
Phone +39 (0) 362 365079
Fax +39 (0) 362 40012
Circuit for generation of digital synchronisation signals
Chugai Boyeki (Deutschland) GmbH
Hansaallee 191
D – 40549 Düsseldorf
Phone +49 (0) 2 11/53 06 70
Fax +49 (0) 2 11/53 06 71 80
Electromagnetic compatibility
The PCB cameras PM200, PMH200, PME200 and PML200 are system components
which are manufactured and supplied only for further integration by companies speciali-
sing in the field of electromagnetic compatibility. They cannot be operated alone. They
can therefore not comply with the safety requirements of the European Guideline 89/
336 and do not bear the CE symbol. The necessary measures for compliance with the
safety requirements and the certificate of conformity must therefore be taken by the
integrating persons or companies.
EMC data or diagrams are available on request from your local Computar service stati-
on.
Rating plates
For exact identification, you will find a numeric code on the 4-pin or 6-pin jack. The
code identifies the following models:
69 PM200
21 PMH200
11 PME200
691 PML200
To Next Page
Loading...