PM200/PMH200/PME200/PML200 (07/98) PM200/PMH200/PME200/PML200 (07/98)
C-SYNC
The following data apply when using a digital composite signal (PME200).
Input tolerances: H: 64 ± 0.128 µs
EQ: 2.35 ± 0.2 µs
HSYNC: 4.7 ± 0.3 µs
Vslow: 27.3 ± 0.3 µs
Input voltage: 4.5 ... 5.0 V
p-p
z
Attention!
If the delay (Tdvs) exceeds the tolerance range of ± 8 µs, there is a
danger of malfunction.
A
Safety information
• Never attempt to connect the camera to any power network other than that for
which it is intended.
• Take appropriate measures to avoid electrostatic discharges as these can damage or
destroy parts of the camera module.
• Integration and installation may only be carried out by qualified specialist personnel.
The relevant regulations of electrical engineering must be observed and complied
with at all times.
• Handle the image sensor (CCD) with great care. Avoid contact with sharp or pointed
objects (e.g. tools). These can cause serious damage to the surface of the image
sensor.
• On no account should the diameter of the existing holes be increased. Reboring
of the holes can destroy the printed conductors of the circuit board.
• When integrating the camera into other equipment, observe the instructions in the
documentation on the other equipment.
Product description
The black-and-white cameras of the PM200 series are among the smallest CCD came-
ras available. They have a 1/3” IT CCD and are supplied either without lens, complete
with a lens of your choice or with a mount for CS lenses. The CS mount permits the use
of all lens types with manual shutter.
All the components are mounted on a 32 × 32 mm printed circuit board. The four pre-
bored holes at the corners are provided for installation of the circuit board. The camera
has an electronic shutter which permits automatic adaptation to changing light conditi-
ons.
Model PM200 has a standard resolution of 380 lines. Model variant PME200 can be
synchronised with an external digital composite signal, model PML200 with an external
digital vertical signal. Model PMH200 operates with a high-resolution CCD with a reso-
lution of 580 lines.
The following lenses are available:
• 2.5 mm
• 3.7 mm pinhole
• 3.8 mm
• 6.0 mm
To Next Page
Loading...