computar PMH200 - User Manual

Installation and Service Information
PCB Cameras
PM200
Read this information before installing, commissioning,
storing or operating the camera.
This Installation and Service Information booklet, edition 01 - 07/98, applies to the
PCB Cameras PM200/PMH200/PME200/PML200 (status 1998)
Environmentally safe disposal
The camera module contains environmentally harmful substances which have to be
disposed of in a special manner. If the module is no longer required, have it disposed of
by a special company or bring it to your local hazardous waste disposal point.
Specifications
Operating voltage 9 V DC ± 10%
Power consumption 120 mA
Image sensor 1/3" IT CCD
Effective pixels PM200/PME200/PML200 512 × 582
PMH200 753 × 582
Resolution PM200/PME200/PML200 380 (h) × 420 (v)
PMH200 550 (h) × 420 (v)
Video system PAL
Scanning system 2:1 interlaced
Synchronisation PM200/PMH200 internal
PME200 internal/external (C-SYNC)
PML200 internal/external (VDSYNC)
Scanning frequency 15625 kHz (h), 50 Hz (v)
S/N ratio 47 dB
Minimum illuminance 0.3 lux (F1.4, 3200 K, 10 IRE)
Gamma factor 0.45
Video signal output VBS 1.0 V
p-p
, 75 ohms
Amplification gain control (AGC) > 12 dB
Electronic shutter speeds PM200 1/50 ... 1/15000 s
PME200/PML200 1/50 ... 1/10000 s
PMH200 1/50 ... 1/80000 s
Operating conditions Temperature: –10 ... +50° C
Relative humidity: 70%, non-condensing
Storage conditions Temperature: –20 ... +60° C
Relative humidity: 70%, non-condensing
Dimensions (W × H × D) 32 × 32 × 14 mm without lens and mount

computar PMH200 Specifications

General

Brand	computar
Model	PMH200
Category	Control Unit
Language	English

Summary

Environmentally safe disposal

Installation and Service Information

Specifications

Detailed technical specifications for PCB cameras, covering operating voltage, power, image sensor, resolution, and video output.

Introduction

Intended use

Defines the professional use of PCB cameras in closed-circuit surveillance systems and restricts other applications.

Electromagnetic compatibility

Rating plates

Circuit for generation of digital synchronisation signals

C-SYNC

Input tolerances

Specifies input tolerances for H, EQ, HSYNC, and Vslow for C-SYNC signals.

Attention!

Warning about potential malfunction if Tdvs exceeds the tolerance range of +/- 8 us.

Safety information

Product description

Lens availability

Lists the available lens options for the PM200 series cameras.

Spectral response curve

Installation

Attention!

Guidance on choosing an installation point considering temperature, moisture, and avoiding direct sunlight.

Connections

Lens

Synchronisation

VDSYNC

Specifies frequency range, stabilization time, and input voltage for VD signal (PML200).