Page
Corr? 0.9784 (Enter recorded correction factor from run to standardize)
60' ET? 1.083 (Enter ET from run to standardize)
Std ET= 1.088 (Standardized ET for selected run)
330' ET? 2.928 (Enter ET from run to standardize)
Std ET= 2.940 (Standardized ET for selected run)
660' ET? 4.445 (Enter ET from run to standardize)
Std ET= 4.464 (Standardized ET for selected run)
1000' ET? 5.774 (Enter ET from run to standardize)
Std ET= 5.798 (Standardized ET for selected run)
1320' ET? 6.918 (Enter ET from run to standardize)
Std ET= 6.947 (Standardized ET for selected run)
1/8 Mile Estimated HP.
This program computes the estimated engine flywheel horsepower based on 1/8 mile elapsed
time and vehicle weight. The HP corrected for the weather conditions is also shown. Use both the
1/8 mile and the 1/4 mile HP estimates to show the effective HP at the different parts of the track.
Press ALT, DRAG PERF., then select Est. 1/8 HP to start this program.
Display Example:
== Est. 1/8 HP ==
1/8mi ET? 4.445 (Enter 1/8 mile ET)
Weight? 1677 (Enter vehicle starting line weight in pounds)
Est. HP= 966 (Estimated flywheel HP)
Corr? 0.9784 (Enter correction factor at time of run)
Corr. HP= 945 (Estimated corrected HP)
1/4 Mile Estimated HP.
This program computes the estimated engine flywheel horsepower based on 1/4 mile elapsed
time and vehicle weight. The HP corrected for the weather conditions is also shown. Use both the
1/8 mile and the 1/4 mile HP estimates to show the effective HP at the different parts of the track.
Press ALT, DRAG PERF., then select Est. 1/4 HP to start this program.
Display Example:
== Est. 1/4 HP ==
1/4mi ET? 6.918 (Enter 1/4 mile ET)
Weight? 1677 (Enter vehicle starting line weight in pounds)
Est. HP= 1001 (Estimated flywheel HP)
Corr? 0.9784 (Enter correction factor at time of run)
Corr. HP= 979 (Estimated corrected HP)
Elapsed Time and MPH Estimate from HP.
This program calculates the estimated elapsed time and MPH for 1/8 and 1/4 mile drag runs. It is
To Next Page