1) Left Audio/AES3 Input: Accepts professional level,
balanced analog audio, or if confi gured, AES3
stereo digital audio for input.
2) Right Audio Input: Accepts professional level,
balanced analog audio.
3) Left Audio/AES3 Output: Delivers professional level,
balanced analog audio, or if confi gured, AES3
stereo digital audio for output.
4) Right Audio Output: Delivers professional level,
balanced analog audio.
5) Ethernet: 10/100baseT connection for network
connections.
6) Power: 4 Pin connector for attachment of Comrex
approved DC power adapter. Requires 24V DC @ 1A
Figure 1 – Rear Panel Diagram and Descriptions
1 2 3 4 5 6
Setting up the Hardware
This document describes how to quickly set up and
use BRIC-Link in its most common, point-to-point
mode. More detailed instructions are contained in
the manual on the CD shipped with the unit. It may
also be downloaded from the Comrex web site at
www.comrex.com
Quick Start Guide
At a minimum, BRIC-Link needs a source of power, an
audio connection, and a network connection.
Audio connections on the 1/4" jacks are wired in the
following fashion:
With a nominal input level of 0dBu (+20 dBu full scale).
You may apply AES3 digital audio to the left I/O
connectors if dip switch #1 (Input) and #2 (output)
are up.
Audio inputs should be
applied and levels checked
with Dip Switch #4 down.
If the audio indicators are
showing red, it indicates
the level is approaching or
reaching clipping stage. It is OK for audio levels to
reach the yellow stage often.
The Ethernet connector is a standard 10/100baseT.
A normal patch cord, such as used for a computer,
should be connected here.
To Next Page
