ComXim MT Series - 8.2.5 Error Code

MT series remote control intelligent turntable user guide
Copyright reserved by Shenzhen ComXim Technology Co., Ltd. 2017
20
8.2.5 Error code
The error code is the parameter of the CR Feedback(CR+ERR=param).
This function can be turned on or off by command "CT+ACK (onOff);".
错误码定义
设备返回命令
含义
31
CR+ERR=31;
Command receive timeout error
40
CR+ERR=40;
The device does not support the command, or the command input
is incorrect.
41
CR+ERR=41;
CT command is ultra short, less than 5 characters (such as shorter
than the shortest command "CT ();")
42
CR+ERR=42;
CT command header error (if not for "CT"), pay attention to
Chinese and English input
43
CR+ERR=43;
CT command connection error (if not "+"), pay attention to
Chinese and English input
45
CR+ERR=45;
CT command parameters start with errors (if not "("), pay
attention to Chinese and English input
46
CR+ERR=46;
CT command parameter end error (if not), pay attention to the
input in English
48
CR+ERR=48;
CT command tail error (if not ";"), pay attention to Chinese and
English input
51
CR+ERR=51;
CT command name character is over length
52
CR+ERR=52;
CT command name illegal
61
CR+ERR=61;
CT command parameter is null character
62
CR+ERR=62;
CT command parameter character is over length
63
CR+ERR=63;
CT command number of parameters out limit
64
CR+ERR=64;
CT command number of parameters does not match
70
CR+ERR=70;
CT command parameters non numeric (71~79 corresponding to
the 1~9 parameters of the error)
80
CR+ERR=80;
The CT command parameter is a numeric value that goes beyond
the valid range (the 81~89 corresponding to the error of the first
1~9 parameter)
9 CT command common debugging tools
Users for the first time using the CT command, it is recommended to use the following sections of the
introduction of the third party Telnet tools, this chapter, respectively, SecureCRT, Windows super terminal as an
example.
Note: SecureCRT, Windows this product with non super terminal software, please users from legitimate
channels.