Concept2 LR2047bcN - Tips for Use

56 57
ENEN
LR2047bcN / LR2047beN / LR2047whN LR2047bcN / LR2047beN / LR2047whN
TIPS FOR USE
• If there is apower failure or the cord has been pulled out of the wall socket, it is necessary to wait at least 5 minutes
before reconnecting the appliance. This 5-minute delay is done to prevent compressor damage.
• During apower failure, food can be stored for several hours inside the refrigerator. Open the door of the refrigerator
as little as possible in order to extend the freshness of the stored food.
• If you do not use the appliance for along time, disconnect the appliance from the mains, clean the inside of the
appliance with non-aggressive detergents (see the Cleaning and Maintenance section) and leave the appliance
door open to prevent unpleasant odours inside the appliance.
• The ambient temperature in the room, the temperature of the food, the amount of food stored, and how often the
door of the appliance gets opened have an effect on the temperature inside the appliance.
• This appliance is designed for use at ambient temperatures of 16 °Cto 43 °C. The appliance may not function
properly if it is used in environment with ambient temperatures listed in the table.
Climate class Ambient Temperature
T 16 °Cup to 43 °C
ST 16 °Cup to 38 °C
N 16 °Cup to 32 °C
SN 10 °Cup to 32 °C
Tips for storing food in arefrigerator
The refrigerator is used to store fresh food for several days.
• Be aware that stored food should not touch the back wall. Leave some space around the individual items to ensure
air circulation in the refrigerator.
• Do not put hot food or drinks in the refrigerator. It will increase the humidity inside the refrigerator.
• Store the food in closed containers or packed.
• Store liquids in closed containers or bottles.
• It is recommended to place the wrapped meat on the glass shelf above the fruit and vegetable drawer.
Please follow the instructions below to avoid degrading of stored food.
• Do not open the refrigerator door for longer than necessary, as the supply of warm air significantly increases
the temperature inside the appliance.
• Clean surfaces that may be in contact with food and drainage channels regularly.
• Fresh meat and fish should be stored in asuitable place to avoid contact with other foods.
USER MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with adamp cloth for hygiene reasons. Wash
all removable parts with warm soapy water.
After installing the refrigerator, leave the appliance standstill for at least half an hour before connecting to the mains.
It is necessary to allow the cooling gases to set down. Then you can connect the refrigerator to the mains and let it run
for 2-3hours to stabilize anormal operating temperature. Aslight odour may occur during this time. It will go away as
soon as the appliance starts to cool. Then put fresh food inside the appliance.
Note: If apower failure occurs during the first run, wait for at least 5 minutes before switching on again or connecting
to the mains.
Setting the Temperature of Refrigerator Zone
1. Open the door of the appliance.
2. Internal temperature of the refrigerator compartment is automatically controlled
by the thermostat (Fig.1).
3. Turning the controller from position OFF to position COLDER sets cooler temperature inside.
• The numbers shown on the controller do not indicate a specific set temperature, but a temperature level
• If the thermostat is set to OFF, it is turned off and the appliance does not cool
• For short-term food storage in the refrigerator, set the thermostat between COLD–NORMAL.
• For long-term food storage in the refrigerator, set the thermostat to position NORMAL and above.
• The refrigerator should be operated for at least 24 hours to reach the desired cooling temperature.
• Recommended setting: NORMAL
Note: Frozen water droplets may appear on the back wall of the refrigerator, it is acommon phenomenon not adefect
of the appliance.
Fig. 1