Concept2 VT 7010 - Product Description

EN
18 VT6930
PRODUCT DESCRIPTION
1. Air inlet grille
2. Air outlet grille
3. Mode selector
4. Thermostat regulator
• Turntheunitoff,disconnectthepowercordfromthewalloutlet,andallowtheunittocoolbeforecleaning.
• Keeptheunitclean;preventforeignbodiesfromenteringthegrilleopenings.Thiscouldcauseashortcircuit,
damage to the unit, or fire.
• Donotuseabrasiveorchemicallyaggressivesubstancestocleantheunit.
• Neverusetheapplianceifthesupplycordorplugisdamaged.Immediatelyrefertoanauthorisedservicecentre
for repair.
• Donotusetheunitifitdoesnotoperateproperly,ifithasbeendropped,damagedorexposedtoanyliquids.
Take the unit to an authorized service centre for testing and repair.
• Theunitisnotdesignedforoutdooruse.
• Theapplianceisintendedfordomesticuseonly,notforcommercialuse.
• Neveroperatetheappliancewithwethands.
• Donotimmersethepowercord,plug,orapplianceinwateroranyotherliquid.
• Theunitisdesignedasanauxiliaryheater,notforthepurposeofoverallheatingofaninterior.
• Theunitshallnotbemountedonthewall.
• Theunitshallnotbeusedinanymeansoftransport.
• Donotrepairtheapplianceyourself.Refertoanauthorizedservicecentreinstead.
Failure to follow the manufacturer‘s instructions may lead to refusal of warranty repair.
2
1
4
3
EN
18 VT6930
PRODUCT DESCRIPTION
1. Air inlet grille
2. Air outlet grille
3. Mode selector
4. Thermostat regulator
• Turntheunitoff,disconnectthepowercordfromthewalloutlet,andallowtheunittocoolbeforecleaning.
• Keeptheunitclean;preventforeignbodiesfromenteringthegrilleopenings.Thiscouldcauseashortcircuit,
damage to the unit, or fire.
• Donotuseabrasiveorchemicallyaggressivesubstancestocleantheunit.
• Neverusetheapplianceifthesupplycordorplugisdamaged.Immediatelyrefertoanauthorisedservicecentre
for repair.
• Donotusetheunitifitdoesnotoperateproperly,ifithasbeendropped,damagedorexposedtoanyliquids.
Take the unit to an authorized service centre for testing and repair.
• Theunitisnotdesignedforoutdooruse.
• Theapplianceisintendedfordomesticuseonly,notforcommercialuse.
• Neveroperatetheappliancewithwethands.
• Donotimmersethepowercord,plug,orapplianceinwateroranyotherliquid.
• Theunitisdesignedasanauxiliaryheater,notforthepurposeofoverallheatingofaninterior.
• Theunitshallnotbemountedonthewall.
• Theunitshallnotbeusedinanymeansoftransport.
• Donotrepairtheapplianceyourself.Refertoanauthorizedservicecentreinstead.
Failure to follow the manufacturer‘s instructions may lead to refusal of warranty repair.
2
1
4
3
OPERATING INSTRUCTIONS
1.Placetheunitonastablesurfaceorfloortopreventitfromtippingover.Removetheentirefeedcordfromthe
storage space and uncoil it.
2. Connect the power cord plug to the wall outlet.
3.Selecttherequiredfunctionusingthemodeselector:
0= Off
= Cool air
=50%heatingcapacity(1,000W)
=Fullheatingcapacity(approximately2,000W)
4.Youmaysettherequiredtemperatureintheroomusingthethermostatregulator.Whenheatingfunction
orisselected,theunitwillalternatelyswitchonandoff,thuskeepingtherequiredtemperature.
Note:Amoreaccuratetemperaturecanbesetasfollows:
 Setthethermostattothemaximum,andswitchtheheatingtoor.Whentherequiredtemperaturehas
been reached in the room, turn the thermostat slowly to a lower temperature, until the unit switches off.
 Ifyouusethefaninthecoolairmode,setthethermostatregulatortothemaximum.
5.Afteruse,movethemodeselectortothe0positionandunplugtheunitfromthemains.
EN
19VT6930
MAINTENANCE AND CLEANING
Warning!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may
damagetheunit’ssurface!
The air inlet andoutletgrillesshouldbecleanedfrequentlytoensureproperoperationoftheunitandtoavoid
overheating.
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
TROUBLESHOOTING
Theunitisequippedwithasafetyfusethatcutsothepowersupplytotheheater,andrestoresitafteritcoolsdown.
Ifthishappensinthecourseofordinaryoperation,checkthecleanlinessoftheinletandoutletgrilles,orchange
location of the unit to improve the air circulation in and around the unit.
Caution
Whenturningtheunitonforthersttimeorafteraprolongeddowntimetheunitmayemitaslightodour.Thisodour
will vanish after a short time.
Note: Do not use the unit in rooms smaller than 4 m
2
.
EN
22 VT 7010
1
2
34