English
Conceptronic HDE01G
1.
Package contents
M.2 SSD Enclosure
USB 3.1 Type-C cable
Screws and screwdriver
Multi language quick installation guide
2.
Installation & usage
Connect to computer
Connect the USB Type-C cable to the enclosure and to a free USB port on your
computer.
The computer will automatically recognize and install the new hardware. No driver
installation is required.
NOTE:
To enjoy USB 3.1 super speed up to 10Gbps, your computer must be equipped
with built-in USB 3.1 ports, or a USB 3.0 host PCI-e card. (If the USB cable is
connected to USB2.0, the transfer speed will down to 480Mbps.)
Disconnect to computer
The M.2 SSD Enclosure must be removed safely before you disconnect it from
your computer, in order to prevent data loss.
Double click on the “Safely Remove Hardware” icon in your system tray.
The “Safely Remove Hardware” window will be shown.
Click on the connected M.2 SSD Enclosure (often listed as “USB Mass Storage
Device”) and click the “Stop” button.
Confirm the disconnection by clicking “OK”.
The M.2 SSD Enclosure is now safely removed from your computer.
To Next Page
Loading...
